Viscosity vs standard and temperature dependence
This assignment paper focuses on Viscosity vs. standard and temperature dependence. This is a technical summary of the contents of the report. Also included is an introduction that discusses the purpose for the experiment and why the knowledge attained from such an investigation is important.
Viscosity vs. standard and temperature dependence
The report will meet a specific requirements;
This is a technical summary of the contents of the report. Also include an introduction that discusses the purpose for the experiment and why the knowledge attain ed from such an investigation is important.
Presented here is a discussion of the underlying engineering principles you are validating by performing the lab.
Firstly, discussion of the available equipment that will be employed, including its limits of applicability and accuracy of measurements.
Steps taken to validate your theory statement. How you employed the equipment used in the lab.
Effective presentation of your collected and calculated data with appropriate use of tables, plots or graphs. Discussion of important aspects of your results with annotation of the results where appropriate and bringing attention to specific aspects in your results (such as a slope in a plot or a break point). The idea here is to present your data with analysis in such a way that it will justify your conclusions as presented in the following section.
NOTE: Sample calculations supporting your results must be presented in the appendix. You need only present the results of the calculations here.
Firstly, Discussion of whether your results validated the theory.
Secondly, Discussion of accuracy in your results.
Thirdly, Discussion of what might have gone wrong if you were not able to validate theory, or had a problem with the experiment.
Your recommendation for further testing and suggestions on how you might implement improvements to your experiment.
Further, What literature research you conducted, and any other constructive suggestions you might wish to make related to this experimental module.
Appendices on: Raw data and its uncertainty (instrumentation and reading error).
• Examples calculations on how you may have employed the raw data. Sample calculations, dimensional analysis (L, T, M, etc.) and explicit documentation (ft., minutes, etc) of engineering units employed for all raw data and derived values. Discuss the accuracy of your result presentation here with consideration of the uncertainty of your raw data.
Lastly, have Supporting references.